Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Vararam
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > General Camaro Forums > Regional Forums > USA - Rockies / Midwest


Reply
 
Thread Tools
Old 11-10-2010, 08:30 AM   #3109
WYcamaro
 
WYcamaro's Avatar
 
Drives: in reverse
Join Date: Oct 2008
Location: I'm Lost....
Posts: 195
Quote:
Originally Posted by 2010 SS RS View Post
Fact is Ted and I did not really have a choice due to internal failures.
didn't have a choice.....

You had a choice, you could have just replaced the piston heads with something stronger and steel rings. You didn't HAVE to bore the engine, you didn't HAVE to stroke it. You didn't HAVE....to...get.....700rwhp+?

huh, now that I think about it... you really didn't have a choice did you? It's like crack.... you just can't stop, there is no choice, just HP and TQ.
WYcamaro is offline   Reply With Quote
Old 11-10-2010, 09:04 AM   #3110
tom692010
Account Suspended
 
Drives: 4 wheels
Join Date: Mar 2009
Location: Here
Posts: 1,402
I guessed I missed something here...What internal failures did you have Larry? What caused it.
tom692010 is offline   Reply With Quote
Old 11-10-2010, 09:11 AM   #3111
2010 SS RS

 
2010 SS RS's Avatar
 
Drives: 2010 2SS/RS IBM Black Polished
Join Date: Feb 2009
Location: Colorado
Posts: 2,106
Quote:
Originally Posted by tom692010 View Post
I guessed I missed something here...What internal failures did you have Larry? What caused it.
I lost compression on number 4..burned ring. Ted cracked a piston #5. Both were due to heat produced from SC. Ted's looked to be way to lean..Possible cause was lack of fuel delivery. Tune on his injectors was set up for 45 lb injectors although he had 52 lb installed. Its always hard to say what caused a failure...Bottom line in my opinion is that the bottom end is fine for stock or very mild numbers but when you put more at it, then you need to upgrade bottome end. Notice the big companies like Lingenfelter change internals....with no choice to make sure they will hold up. So there is no bolt on power adder that should be done without addressing the internals in my opinion. Believe me when I say...I would have been fine with the 578 rwhp I had if the internals had held up. But since they did not why not do it right! lol
__________________
418 Stroker, 621RWHP 648 lbs TORQUE Built by Laramie GM Auto Center Tuned by Nick at Mac Autosport. EForce SC, 2 3/4pulley,LPE dual fuel pump, JRE Twin fuel rail upgrade, posi clutch kit, RX oilcatch can and breather, Callies Compstar crankshaft and rods, Racing bearings, CP -13.8 race pistons, steel rings, Comp Cams X6 blower cam, Springs, HD timing chain and tensioner, Doug Thorley Tri Y LT headers, 89.7lb injectors, RPM rollbar, DSS1400 shafts, Simpson 5 pt harness, BMR Toe rods and trailing arms, led lights, RPM input and output shafts
2010 SS RS is offline   Reply With Quote
Old 11-10-2010, 01:34 PM   #3112
tom692010
Account Suspended
 
Drives: 4 wheels
Join Date: Mar 2009
Location: Here
Posts: 1,402
Ok the failures happen after you instaled the sc right? Just want to make sure it wasn't pre sc. I'm no where near the 500 rwhp so I won't be concerned.
tom692010 is offline   Reply With Quote
Old 11-10-2010, 03:24 PM   #3113
Icntdrv55
CCOTR Member
 
Icntdrv55's Avatar
 
Drives: Victory Red 2010 2SS/RS A6
Join Date: Jun 2009
Location: Parker CO
Posts: 1,096
500 RWHP in a Mini Cooper........
__________________
Camaro Club Of The Rockies (CCOTR) Check us out on Facebook!
---------------------------
2010 Camaro SS/RS Victory Red A6- Vararam Intake, Doug Thorley Tri Y LTs, Magnaflow X-pipe, Flowmaster Super 40's, VMS Tune, Razzi Ground Effects, Herritage Grill, RED headlight and fog light Halos, LED DRLs, Dash and extended Door ABL, engine, grill and rear defusser LED lighting ........ 12.59@112.21 (DA Corrected)
Icntdrv55 is offline   Reply With Quote
Old 11-10-2010, 03:46 PM   #3114
tom692010
Account Suspended
 
Drives: 4 wheels
Join Date: Mar 2009
Location: Here
Posts: 1,402
Only if I'm pushing it with the camaro and there's a real strong wind.....

we need to start another thread here.....this one takes forever to comeup because of the pictures....I think......yes I have a fast computer.
tom692010 is offline   Reply With Quote
Old 11-10-2010, 07:07 PM   #3115
pumpkinrancho
COMPULSIVE CAMARO OWNER
 
pumpkinrancho's Avatar
 
Drives: 18 ZLE,14 2ssrs,96,73 RS LT,69&67
Join Date: Nov 2009
Location: SE. WYO & Northern CO, W NEB
Posts: 1,238
Quote:
Originally Posted by Icntdrv55 View Post
500 RWHP in a Mini Cooper........
I have to admit I would want to drive it at least once...
__________________
pumpkinrancho is offline   Reply With Quote
Old 11-10-2010, 07:28 PM   #3116
pumpkinrancho
COMPULSIVE CAMARO OWNER
 
pumpkinrancho's Avatar
 
Drives: 18 ZLE,14 2ssrs,96,73 RS LT,69&67
Join Date: Nov 2009
Location: SE. WYO & Northern CO, W NEB
Posts: 1,238
Does anybody know how to post an adobe file on here?
__________________
pumpkinrancho is offline   Reply With Quote
Old 11-10-2010, 08:29 PM   #3117
BUMBLEB
IN GOD WE THRUST
 
BUMBLEB's Avatar
 
Drives: 2010 RY 2SS RS M6 TVS2300 2015 Z06
Join Date: Sep 2009
Location: PARKER,CO
Posts: 284
Quote:
Originally Posted by 2010 SS RS View Post
I lost compression on number 4..burned ring. Ted cracked a piston #5. Both were due to heat produced from SC. Ted's looked to be way to lean..Possible cause was lack of fuel delivery. Tune on his injectors was set up for 45 lb injectors although he had 52 lb installed. Its always hard to say what caused a failure...Bottom line in my opinion is that the bottom end is fine for stock or very mild numbers but when you put more at it, then you need to upgrade bottome end. Notice the big companies like Lingenfelter change internals....with no choice to make sure they will hold up. So there is no bolt on power adder that should be done without addressing the internals in my opinion. Believe me when I say...I would have been fine with the 578 rwhp I had if the internals had held up. But since they did not why not do it right! lol
3500 miles on mine with MAGGIE no bottom end problems yet??? Hope i dont have any!!!
__________________
BUMBLEB is offline   Reply With Quote
Old 11-10-2010, 09:52 PM   #3118
2010 SS RS

 
2010 SS RS's Avatar
 
Drives: 2010 2SS/RS IBM Black Polished
Join Date: Feb 2009
Location: Colorado
Posts: 2,106
Quote:
Originally Posted by BUMBLEB View Post
3500 miles on mine with MAGGIE no bottom end problems yet??? Hope i dont have any!!!
hope you dont either...what is your set up include? Garth seems fine with his maggie as well but he does already have forged bottom end. He also has installed twin fuel pump and BAP and controller. He had failure on first BAP and would have screwed up his bottom end if it was not already forged.

Larry
__________________
418 Stroker, 621RWHP 648 lbs TORQUE Built by Laramie GM Auto Center Tuned by Nick at Mac Autosport. EForce SC, 2 3/4pulley,LPE dual fuel pump, JRE Twin fuel rail upgrade, posi clutch kit, RX oilcatch can and breather, Callies Compstar crankshaft and rods, Racing bearings, CP -13.8 race pistons, steel rings, Comp Cams X6 blower cam, Springs, HD timing chain and tensioner, Doug Thorley Tri Y LT headers, 89.7lb injectors, RPM rollbar, DSS1400 shafts, Simpson 5 pt harness, BMR Toe rods and trailing arms, led lights, RPM input and output shafts
2010 SS RS is offline   Reply With Quote
Old 11-11-2010, 06:51 PM   #3119
pumpkinrancho
COMPULSIVE CAMARO OWNER
 
pumpkinrancho's Avatar
 
Drives: 18 ZLE,14 2ssrs,96,73 RS LT,69&67
Join Date: Nov 2009
Location: SE. WYO & Northern CO, W NEB
Posts: 1,238
Here is the flyer for the toy cruise this saturday in Cheyenne. https://docs.google.com/viewer?a=v&p...ZGFlNTIx&hl=en
__________________
pumpkinrancho is offline   Reply With Quote
Old 11-12-2010, 09:04 AM   #3120
pumpkinrancho
COMPULSIVE CAMARO OWNER
 
pumpkinrancho's Avatar
 
Drives: 18 ZLE,14 2ssrs,96,73 RS LT,69&67
Join Date: Nov 2009
Location: SE. WYO & Northern CO, W NEB
Posts: 1,238
Quote:
Originally Posted by 2010 SS RS View Post
I lost compression on number 4..burned ring. Ted cracked a piston #5. Both were due to heat produced from SC. Ted's looked to be way to lean..Possible cause was lack of fuel delivery. Tune on his injectors was set up for 45 lb injectors although he had 52 lb installed. Its always hard to say what caused a failure...Bottom line in my opinion is that the bottom end is fine for stock or very mild numbers but when you put more at it, then you need to upgrade bottome end. Notice the big companies like Lingenfelter change internals....with no choice to make sure they will hold up. So there is no bolt on power adder that should be done without addressing the internals in my opinion. Believe me when I say...I would have been fine with the 578 rwhp I had if the internals had held up. But since they did not why not do it right! lol
Did you and ted have the original edlebrock sc pulley, or the higher boost one?
__________________
pumpkinrancho is offline   Reply With Quote
Old 11-12-2010, 09:09 AM   #3121
pumpkinrancho
COMPULSIVE CAMARO OWNER
 
pumpkinrancho's Avatar
 
Drives: 18 ZLE,14 2ssrs,96,73 RS LT,69&67
Join Date: Nov 2009
Location: SE. WYO & Northern CO, W NEB
Posts: 1,238
Quote:
Originally Posted by pumpkinrancho View Post
Here is the flyer for the toy cruise this saturday in Cheyenne. https://docs.google.com/viewer?a=v&p...ZGFlNTIx&hl=en
I will try it again.
__________________
pumpkinrancho is offline   Reply With Quote
Old 11-12-2010, 09:57 AM   #3122
tom692010
Account Suspended
 
Drives: 4 wheels
Join Date: Mar 2009
Location: Here
Posts: 1,402
Lets all trade in our Camaros for the new Boss 302. We can get 2 keys instead of 1. Now that's the option I've been waiting for..............
tom692010 is offline   Reply With Quote
Reply

Tags
2012 callaway, 45th anniversary, colorado camaro


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Old school members! 4thGenRocks Off-topic Discussions 14 07-06-2010 05:00 PM
For Sale: 2007 Chev Colorado EXT Cab Z71 4X4 bluch Autos For Sale / Wanted 7 06-25-2009 03:03 PM
Check out this web site i found ezlock83 5th Gen Camaro SS LS LT General Discussions 5 03-04-2009 01:44 PM
Voice Your Comments/Suggestions/Input for Focus Group on 2010 Camaro Mr. Wyndham 5th Gen Camaro SS LS LT General Discussions 236 04-22-2008 01:43 AM
# Of Members TAG UR IT Site Related Announcements / Suggestions / Feedback / Questions 25 03-16-2008 12:47 PM


All times are GMT -5. The time now is 10:20 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2025, vBulletin Solutions, Inc.