EVERYBODY POST YOUR DYNO NUMBERS!(sticky request) - Page 24 - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

chozn4service · 01-21-2013, 03:16 PM

Here's mine from Mike Norris Motorsports. I might add this was before the VMax Black Ice-O-Later & Ported Throttle Boby, Flowmaster Catback exhaust and my Trifecta Tune. This was captured on our first Dyno Day here in Indy back on October 2Nd or the 9Th. I've yet to get it back on the Dyno with everything I have going now but this was just with the Flowmaster axleback and Airaid CAI at the that time.

trooper182 · 01-21-2013, 03:58 PM

Did this one last year. Was attempting to install a nitrous kit but had some issues so the kit never got installed. But still got some dyno time in. Hopefully this summer I will have more parts on the car and will get another run it.
Mods at the time: MRT V1.0, resonator delete, Roto-Fab cold air intake

KMPrenger · 01-21-2013, 05:30 PM

Wow three additions all of a sudden lol.

I'll work on getting them added, but first:

chozn, it looks like your dyno has already been added to this sheet.

Trooper do you remember the gear used and temp? Are you manual or auto?

Thanks guys

KMPrenger · 01-21-2013, 06:01 PM

Updated.

KMPrenger · 03-17-2013, 09:52 PM

Korrosion's and Stand-al0ne's dyno runs added to list (appear on sheet 3)

Botoasy · 04-07-2013, 07:05 PM

This may be a dumb question but is there a benefit to dyno a car with the traction control off?

kjkjr27 · 05-03-2013, 08:06 PM

Should be getting a dyno done tomorrow finally. Don't know how accurate it will be since it will be a portable one but we will see!

RubyCamaro · 05-03-2013, 09:37 PM

nevermind

73vette · 06-15-2013, 06:53 PM

Does my dyno look normal? I thought I would be putting down a little more power.. Best run was 224rwhp, 231rwtq.

I have a 2010 LS A6, vararam, resonator delete, and magna flow mufflers.

Humidity 54% but it just finished raining.
80 degrees (F)
STD: 1.06
28.95 in-Hg
4th gear

GretchenGotGrowl · 06-15-2013, 08:09 PM

Quote:

Originally Posted by 73vette

Does my dyno look normal? I thought I would be putting down a little more power.. Best run was 224rwhp, 231rwtq.

I have a 2010 LS A6, vararam, resonator delete, and magna flow mufflers.

Humidity 54% but it just finished raining.
80 degrees (F)
STD: 1.06
28.95 in-Hg
4th gear

Thet didn't pull it up to high enough RPMs. They should have pulled all the way to 7000.

Sent from my SPH-D710 using Tapatalk 2

73vette · 06-15-2013, 08:26 PM

Quote:

Originally Posted by GretchenGotGrowl

Thet didn't pull it up to high enough RPMs. They should have pulled all the way to 7000.

Sent from my SPH-D710 using Tapatalk 2

Any reason they wouldn't have? Other than everyone else was 800+rwhp cars? (And I was probably sluffed off?). The vette before me pulled 839, the gto after was 851!

GretchenGotGrowl · 06-15-2013, 08:30 PM

Quote:

Originally Posted by 73vette

Any reason they wouldn't have? Other than everyone else was 800+rwhp cars? (And I was probably sluffed off?). The vette before me pulled 839, the gto after was 851!

I don't know. The LS motors do peak earlier than the HF V6s, but most will still make the pull to at least 6500 RPM.

73vette · 06-15-2013, 08:33 PM

Quote:

Originally Posted by GretchenGotGrowl

I don't know. The LS motors do peak earlier than the HF V6s, but most will still make the pull to at least 6500 RPM.

Should I try to get another one done for free? Or just call it a loss?

GretchenGotGrowl · 06-15-2013, 09:04 PM

Quote:

Originally Posted by 73vette

Should I try to get another one done for free? Or just call it a loss?

I would call them and ask why they didn't pull it all the way up to red line. Let them know your peak power is around 6800 RPM, and if you don't have a good baseline you won't have anything to compare to when you add mods.

01-21-2013, 03:16 PM	#323
chozn4service Drives: 2016 SS w/2SS A8 Blue Velvet Join Date: Dec 2009 Location: 39.793153,-86.238223 Posts: 3,678 View My Garage	Here's mine from Mike Norris Motorsports. I might add this was before the VMax Black Ice-O-Later & Ported Throttle Boby, Flowmaster Catback exhaust and my Trifecta Tune. This was captured on our first Dyno Day here in Indy back on October 2Nd or the 9Th. I've yet to get it back on the Dyno with everything I have going now but this was just with the Flowmaster axleback and Airaid CAI at the that time. Attached Images __________________ Never grow up, it's a trap!

01-21-2013, 03:58 PM	#324
trooper182 Drives: 2011 Camaro 1LT yellow non RS Join Date: May 2011 Location: Louisiana Posts: 691	Did this one last year. Was attempting to install a nitrous kit but had some issues so the kit never got installed. But still got some dyno time in. Hopefully this summer I will have more parts on the car and will get another run it. Mods at the time: MRT V1.0, resonator delete, Roto-Fab cold air intake Attached Images __________________ Staff Sergeant U.S. Army 13B Gun Bunny. 2011 Camaro 1LT A6 Mods: Pypes bomb V8 exhaust, Magnaflow x-pipe, resonator delete, Roto-Fab cold air intake, Vmax Black Ice-olator, Elite Engineering catch can, painted engine cover and fuse box cover, 3dCarbon Front Fender Vents, Street Scene Front Splitter, ZL1 Side Rockers, Anvil Notch Rear Spoiler, interior/engine bay LED lights, two JL Audio W3's 10" and 1000w kenwood amp

01-21-2013, 05:30 PM	#325
KMPrenger Drives: 16 Camaro SS, 15 Colorado Join Date: May 2009 Location: Jefferson City, Missouri Posts: 13,943	Wow three additions all of a sudden lol. I'll work on getting them added, but first: chozn, it looks like your dyno has already been added to this sheet. Trooper do you remember the gear used and temp? Are you manual or auto? Thanks guys __________________ 2016 Camaro 1SS - 8-speed - NPP - Black bowties 2010 Camaro 1LT V6 (Sold. I will miss her!) Last edited by KMPrenger; 01-21-2013 at 05:42 PM.

01-21-2013, 06:01 PM	#326
KMPrenger Drives: 16 Camaro SS, 15 Colorado Join Date: May 2009 Location: Jefferson City, Missouri Posts: 13,943	Updated. __________________ 2016 Camaro 1SS - 8-speed - NPP - Black bowties 2010 Camaro 1LT V6 (Sold. I will miss her!)

03-17-2013, 09:52 PM	#327
KMPrenger Drives: 16 Camaro SS, 15 Colorado Join Date: May 2009 Location: Jefferson City, Missouri Posts: 13,943	Korrosion's and Stand-al0ne's dyno runs added to list (appear on sheet 3) __________________ 2016 Camaro 1SS - 8-speed - NPP - Black bowties 2010 Camaro 1LT V6 (Sold. I will miss her!)

04-07-2013, 07:05 PM	#328
Botoasy Drives: 2015 RRM 1LE Join Date: Dec 2011 Location: Blackwood, New Jersey Posts: 446 View My Garage	This may be a dumb question but is there a benefit to dyno a car with the traction control off? __________________ 2015 Camaro 1LE: CAI, LT Headerrs, Cam 2010 Camaro LS: BBK Longtube Headers with Hi Flow Cats, BBK CAI, SLP Loudmouth 1 exhaust, Magnaflow X-pipe and Resonators, Ported TB, Mace Ported IM and Spacer,Trifecta Tune, Elite Catch Can, Hotchkis front and rear sway bars. SOLD!!! My Build Thread: http://www.camaro5.com/forums/showthread.php?t=27276 5

05-03-2013, 08:06 PM	#329
kjkjr27 COTW 9/16/13 Drives: 2011 2LT/RS Camaro IOM Join Date: Jan 2012 Location: Syracuse Posts: 10,089	Should be getting a dyno done tomorrow finally. Don't know how accurate it will be since it will be a portable one but we will see! __________________ Twitch Youtube

05-03-2013, 09:37 PM	#330
RubyCamaro Jan Drives: 2010 Camaro 1LT Red Jewel tintcoat Join Date: May 2010 Location: Springfield, TN Posts: 16,225 View My Garage	nevermind __________________

06-15-2013, 06:53 PM	#331
73vette Drives: 2010 Camaro LS, 1973 Corvette Join Date: Dec 2010 Location: Olathe, KS Posts: 807 View My Garage	Does my dyno look normal? I thought I would be putting down a little more power.. Best run was 224rwhp, 231rwtq. I have a 2010 LS A6, vararam, resonator delete, and magna flow mufflers. Humidity 54% but it just finished raining. 80 degrees (F) STD: 1.06 28.95 in-Hg 4th gear __________________ Last edited by 73vette; 06-15-2013 at 07:55 PM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Roto-fab CAI dyno results	Roto-fab 1	Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons	102	07-30-2016 07:21 PM
Dyno numbers are in after heads,Maggie install	papabearcamaro	Forced Induction - V8	17	05-14-2011 08:36 PM
Some L99 Dyno Numbers	JLBIII	Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons	1	02-20-2011 01:34 AM
ls3 mustang dyno numbers	8secpumpgas	Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons	6	06-16-2010 12:38 AM
dyno numbers for my build are in (cam + nitrous)	mark_p	Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons	5	09-10-2009 10:22 AM