How Many Use The DashLogic on there ZL1?

[2013 ZL1 #7860]

Originally Posted by tnspd

The exhaust flaps work off of vacuum. You have to have the car started to close them. You cannot start the car with them closed, no vaccum yet.

Sent from my SPH-L710 using Tapatalk

Bummer, Makes sense. Thank you!

I start the car and unless I wait 2 minutes or so of idle or driving, if I close the valves they make a loud noise.

Is this normal?

Is the car "building" vacuum in this time? (doubt it)

Should I be looking for a vacuum leak? Maybe one that seals itself when it gets warm?

[jon6.0]

I shut my flaps right away after I start my car and I have no weird noises.

[wirebender]

v1.18A is an improvement but still has some bugs to work out...tranny temp sticks on 32F half the time at start up....hmmmm

[Skylane765]

Originally Posted by JacobC1983

Went for my first drive without dashlogic freezing! Things are looking up!

My dash logic is on my Z28 and ZL1, the dash logic would freeze on the ZL1 but not the Z28. I switched them and now either one freezes.

[Skylane765]

Originally Posted by PalmerPerformance

If you don't touch the cruise toggle, it is factory controlled.

When is it factory controlled? if the CC switch is never in the on position, it seems it is always in power mode??

[camguynj]

Originally Posted by Skylane765

My dash logic is on my Z28 and ZL1, the dash logic would freeze on the ZL1 but not the Z28. I switched them and now either one freezes.

What version do you have?

[JacobC1983]

Mine froze again. Damnit-- 2nd drive after update.

Are people freezing with and without the extension cable?

[camguynj]

Originally Posted by JacobC1983

Mine froze again. Damnit-- 2nd drive after update.

Are people freezing with and without the extension cable?

What version?

[JacobC1983]

1.18a

[Rube]

1.17 and no lockups (no extension cable)...so far on a '13 ZL1. But get nothing on the My Link radio display. And cant hear any chimes on the alerts.

[jon6.0]

Originally Posted by Rube

1.17 and no lockups (no extension cable)...so far on a '13 ZL1. But get nothing on the My Link radio display. And cant hear any chimes on the alerts.

The chimes aren't that loud and if your flaps are open you won't hear them. I tried to use mine as a shift warning. Doesn't work, lol. I can't hear it. I now have the HUD say "SHIFT!" when it gets to 5900rpm. That mostly works, but sometimes I still hit the limiter in 1st.

[ZL1_TA]

Originally Posted by Rube

1.17 and no lockups (no extension cable)...so far on a '13 ZL1. But get nothing on the My Link radio display. And cant hear any chimes on the alerts.

I found the same thing so updated to the latest firmware and it started to show up but not all of the time.... I found that if you hit the commands button when the little nav screen shows up right after you start the car then it sticks but still not sure what is causing it to disappear.... Everything else works great... Love the product!

[Rube]

yesterday it showed up on the radio for the first time, after I adjusted the volume with the steering wheel controls. But couldn't duplicate it again. it does pop up during bootup, but then disappears.
Also, Engine Oil Life (pid 1006 I believe) dont work.

[RLHMARINES]

May radio display for Dashlogic comes on but I also must hit the command button on the radio and hit the back button for the read outs to stay on the radio. I sometimes while driving will have to toggle the switch to config and then back to profile to reset it.