Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Bigwormgraphix
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 2 1 2
Showing results 1 to 30 of 51
Search took 0.01 seconds. Search: Posts Made By: bad55nomad
Forum: Dragstrip and Launch Techniques Discussion 07-17-2012, 12:12 PM
Replies: 9
Views: 2,635
Posted By bad55nomad
Did you run your car before the gear swap ? ...

Did you run your car before the gear swap ? Interested if you seen any gains in ET .
Forum: Dragstrip and Launch Techniques Discussion 06-27-2012, 12:34 PM
Replies: 54
Views: 6,413
Posted By bad55nomad
I agree with Sc2150 get a converter . Dropped my...

I agree with Sc2150 get a converter . Dropped my 60 by .3 and the 1/4 mile by .7
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-26-2012, 07:23 PM
Replies: 9
Views: 5,054
Posted By bad55nomad
I had the same problem ending up being ported...

I had the same problem ending up being ported throttle body . Took it off problem solved
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-17-2012, 12:17 PM
Replies: 21
Views: 3,041
Posted By bad55nomad
I got the ceramic coated pacesetters and cats for...

I got the ceramic coated pacesetters and cats for $ 495 shipped off Amazon.com
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-16-2012, 12:41 PM
Replies: 21
Views: 3,041
Posted By bad55nomad
I have had them on for a year . Still look as...

I have had them on for a year . Still look as good as the day I put them on and they fit nice . I also used their Cats
Forum: Dragstrip and Launch Techniques Discussion 04-27-2012, 07:41 PM
Replies: 19
Views: 3,388
Posted By bad55nomad
The 305 drove fine and fit fine on stock rims , ...

The 305 drove fine and fit fine on stock rims , They are a little heavy and if I didnt go to a 18" rim I would stay with the 275 . They stick fine at the track just heat them up good .
Forum: Dragstrip and Launch Techniques Discussion 04-26-2012, 12:20 PM
Replies: 19
Views: 3,388
Posted By bad55nomad
18-20 pounds . Play around between there for...

18-20 pounds . Play around between there for best 60 ft
Forum: Transmission / Driveline 04-22-2012, 08:39 PM
Replies: 4
Views: 1,495
Posted By bad55nomad
yes

yes
Forum: Transmission / Driveline 02-23-2012, 07:31 AM
Replies: 4
Views: 1,495
Posted By bad55nomad
Stock Converter for 6L80E

Stock converter out of 2010 SS . 2500 miles removed last winter when I went to a Yank3200 . $ 75.00 shipped Want it out of the garage


Thanks
Forum: Wheels / Tires 02-07-2012, 10:55 AM
Replies: 5
Views: 1,412
Posted By bad55nomad
SOLD !!!!!!!!!!!!!!!!

SOLD !!!!!!!!!!!!!!!!
Forum: Wheels / Tires 02-06-2012, 06:37 PM
Replies: 5
Views: 1,412
Posted By bad55nomad
R and L to Danville ( 39 miles )

R and L to Danville ( 39 miles )
Forum: Wheels / Tires 02-06-2012, 05:17 PM
Replies: 5
Views: 1,412
Posted By bad55nomad
FS: 20" Midnight silver rims , tires , TPMS , Lugs

20" MS rims with stock Pzero mounted front ( 4000 miles ) , Rear mounted with 305 Nittos 555R ( 2500 miles ) . Also is included stock Pzero tires ( 1500 miles ) not mounted . Tpms and lugs included...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 05-27-2011, 06:57 AM
Replies: 7
Views: 1,376
Posted By bad55nomad
Vmax Ported TB

Returning my car to stock . TB has about 300 miles on it since getting it back . Would trade for a untouched TB
Forum: Tuning / Diagnostics -- engine and transmission 05-16-2011, 06:13 PM
Replies: 23
Views: 8,716
Posted By bad55nomad
Your fuel trims are way off . I added LT , NEW...

Your fuel trims are way off . I added LT , NEW ERA , PORTED TB and was setting the same 2 codes . Did some datalogging with LS2 scanner and my LTFT were 24 at cruise . Vector got me squared away .
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-01-2011, 07:44 PM
Replies: 9
Views: 2,145
Posted By bad55nomad
No pics yet . Finally got some good weather and...

No pics yet . Finally got some good weather and went on 100 mile cruise . Well got a CEL and the car started surging at cruise . Hopefully Steve at Vector can get me squared away my home track...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-28-2011, 01:00 PM
Replies: 9
Views: 2,145
Posted By bad55nomad
YANK 3200 INSTALLED

Just finished up installing my Yank 3200 , Pacestter 1 3/4 , Vmax throttle body , New era intake . I had a tune by Vector motorsports before and Steve over there was good enough to send me over a...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-23-2011, 07:26 PM
Replies: 105
Views: 21,385
Posted By bad55nomad
I had my lifters updated due to a cold start tick...

I had my lifters updated due to a cold start tick back in November . I was told GM got a bad batch of AFM lifters from one certain vender and when doing the replacement they use another vendor . ...
Forum: Tuning / Diagnostics -- engine and transmission 03-15-2011, 03:58 AM
Replies: 1
Views: 1,191
Posted By bad55nomad
Mine does that every once in a while . Try...

Mine does that every once in a while . Try unplugging and plugging back into the OBD port before you connect to the ECM .
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-10-2011, 04:01 AM
Replies: 8
Views: 2,469
Posted By bad55nomad
Converter Install

Anyone install a bigger converter in their car ? If so how did you monitor the tranny fluid temps to properly refill ? I only have a 1SS . I have a pyrometer with a thin wire probe I was thinking...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-08-2011, 06:58 AM
Replies: 2
Views: 1,671
Posted By bad55nomad
Torque Converter Install

For those guys out there with bigger stalls and installed yourself how did you monitor tranny fluid temps to make sure you were in the right temp range to refill ? Is there anyway of hooking up a...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-14-2011, 06:50 PM
Replies: 39
Views: 4,974
Posted By bad55nomad
Just got my Pacesetters . Havent installed them...

Just got my Pacesetters . Havent installed them yet . The quality looks good for the price ceramic coated
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-14-2011, 05:38 PM
Replies: 152
Views: 16,582
Posted By bad55nomad
You should already have my core

You should already have my core
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 01-06-2011, 11:49 AM
Replies: 29
Views: 12,699
Posted By bad55nomad
Had ,mine done back in November and no issues...

Had ,mine done back in November and no issues since
Forum: Dragstrip and Launch Techniques Discussion 01-06-2011, 03:48 AM
Replies: 53
Views: 24,895
Posted By bad55nomad
I dont think it would be a pain . You go 12 volt...

I dont think it would be a pain . You go 12 volt source to toggle switch / out of the toggle switch to the mico switch mounted on the brake pedal / out of the mico switch to the MSD 2 step...
Forum: Dragstrip and Launch Techniques Discussion 01-04-2011, 04:28 AM
Replies: 53
Views: 24,895
Posted By bad55nomad
GQ4LIFE is talking about a neutral drop . Which...

GQ4LIFE is talking about a neutral drop . Which is not a good idea and wrong for so many reasons . MERCURYMAN is talking about installing the 2 step to get his 60ft more consistant . I would say...
Forum: Dragstrip and Launch Techniques Discussion 01-02-2011, 08:13 PM
Replies: 53
Views: 24,895
Posted By bad55nomad
yes but you will need a micro switch to activate...

yes but you will need a micro switch to activate the 2 step
Forum: Tuning / Diagnostics -- engine and transmission 12-05-2010, 12:47 PM
Replies: 35
Views: 8,177
Posted By bad55nomad
Just had my A6 in to the dealer for lifter...

Just had my A6 in to the dealer for lifter replacement . Vector tune flashed back to stock they counted tell . So take it for what its worth
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 12-04-2010, 05:58 PM
Replies: 159
Views: 34,941
Posted By bad55nomad
Picked the car up today . Sounds good . They used...

Picked the car up today . Sounds good . They used PN# 17122490 which is a lS7 lifter and PN# 12632143 which is the standard AFM lifter . $ 2200 in warranty work
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 12-03-2010, 03:30 AM
Replies: 159
Views: 34,941
Posted By bad55nomad
Dealer called yesterday and car is done . They...

Dealer called yesterday and car is done . They want to keep it 1 more day to do a couple cold starts . Hope all is good
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 12-01-2010, 01:39 PM
Replies: 159
Views: 34,941
Posted By bad55nomad
Thats what I meant . He said its silly to have...

Thats what I meant . He said its silly to have the dealer open the engine over silly lifters .
Showing results 1 to 30 of 51
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -5. The time now is 06:33 AM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2025, vBulletin Solutions, Inc.