Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Bigwormgraphix
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read


Page 1 of 2 1 2
Showing results 1 to 30 of 41
Search took 0.01 seconds; generated 43 minute(s) ago. Search: Posts Made By: RIDE-F-X
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 05-03-2012, 12:43 PM
Replies: 65
Views: 12,632
Posted By RIDE-F-X
Dang, you could almost sell that thing I bet....

Dang, you could almost sell that thing I bet. Especially for apartment complex garages where you might not know who is parking next to you.
Forum: Suspension / Brakes / Chassis 04-30-2012, 02:33 PM
Replies: 14
Views: 4,874
Posted By RIDE-F-X
I was curious how many other people saw this, I...

I was curious how many other people saw this, I was going to see how long it will take to fatigue the tops of the strut stems from being over-constrained when people start filling up that necessary...
Forum: New Member Introductions 04-26-2012, 01:08 PM
Replies: 37
Views: 5,865
Posted By RIDE-F-X
Sweet ride but man I feel bad seeing snow around!

Sweet ride but man I feel bad seeing snow around!
Forum: Cosmetics and Lighting Modification Discussions 03-14-2012, 12:49 PM
Replies: 56
Views: 7,617
Posted By RIDE-F-X
Interested in this as well! Shoot me a PM...

Interested in this as well! Shoot me a PM...
Forum: Suspension / Brakes / Chassis 03-02-2012, 12:45 PM
Replies: 1
Views: 1,095
Posted By RIDE-F-X
I have rotors with not even 4,500 miles on them...

I have rotors with not even 4,500 miles on them if you find the rest of the pieces you need.
Forum: Suspension / Brakes / Chassis 02-27-2012, 12:50 PM
Replies: 4
Views: 2,849
Posted By RIDE-F-X
There absolutely is a big difference is motion...

There absolutely is a big difference is motion ratio. The front strut bolts right to the knuckle, where-as the rear is a leverage system with the coil over being mounted on the lower control arm. You...
Forum: Suspension / Brakes / Chassis 02-24-2012, 01:06 PM
Replies: 18
Views: 15,612
Posted By RIDE-F-X
That's some nice innovative stuff, great job...

That's some nice innovative stuff, great job guys. I've seen those in the offroad industry when guys want the sway bar stiff on the street but soft offroad. The pillow blocks are a nice addition,...
Forum: Suspension / Brakes / Chassis 02-23-2012, 01:16 PM
Replies: 30
Views: 4,073
Posted By RIDE-F-X
I knew it was normal on mine too, but it was such...

I knew it was normal on mine too, but it was such a eye sore for a brand new vehicle. Ordered a set of black zinc plated rotors from Granatelli and now it looks like it should have!
Forum: Suspension / Brakes / Chassis 02-13-2012, 12:39 PM
Replies: 24
Views: 3,947
Posted By RIDE-F-X
I would just unbolt the brackets and the links....

I would just unbolt the brackets and the links. We did not want to bother with moving the rack or lifting up the motor. Less bolts you touch the less problems you could introduce! Yes it took a...
Forum: Suspension / Brakes / Chassis 02-01-2012, 01:11 PM
Replies: 35
Views: 6,919
Posted By RIDE-F-X
Is there a shaft collar bolted onto the sway bar...

Is there a shaft collar bolted onto the sway bar to keep the bar centered? I would check to make sure the sides of the collar where it will rub the bushing is lubed as well.
Forum: Suspension / Brakes / Chassis 01-25-2012, 12:38 PM
Replies: 212
Views: 25,256
Posted By RIDE-F-X
Yeah Track Nights I usually have a cooler with...

Yeah Track Nights I usually have a cooler with bags of ice and in between runs soaking the intake manifold and intake tube with bags of ice. Not sure if it makes a huge difference, but you got to try...
Forum: Suspension / Brakes / Chassis 01-24-2012, 01:03 PM
Replies: 212
Views: 25,256
Posted By RIDE-F-X
:thumbup: Nice!! Just wait till you have some hot...

:thumbup: Nice!! Just wait till you have some hot 90* pavement to stick to! These cars are great once they get some suspension performance in them. Mine's tucked away in storage :(
Forum: Camaro Photos | Spyshots | Video | Media Gallery 01-18-2012, 12:46 PM
Replies: 14
Views: 2,734
Posted By RIDE-F-X
If you're doing something as custom as paint, why...

If you're doing something as custom as paint, why not make it look a little different than the factory vinyls to let it stand out? Maybe take the front stripes down the bumper, or maybe invert the...
Forum: Suspension / Brakes / Chassis 01-09-2012, 12:58 PM
Replies: 212
Views: 25,256
Posted By RIDE-F-X
That's tough, you put alot of personal research...

That's tough, you put alot of personal research in it. Alot of customers would have came on here and blasted the company from the beginning. Hope you next move works out for the better.
Forum: Suspension / Brakes / Chassis 01-04-2012, 12:55 PM
Replies: 212
Views: 25,256
Posted By RIDE-F-X
I agree it could be a long shot for his...

I agree it could be a long shot for his application. Unless the shocks/struts were completely whipped and maybe the different spring rate cause more load? I just knew it was a major finding in the...
Forum: Suspension / Brakes / Chassis 01-03-2012, 01:08 PM
Replies: 212
Views: 25,256
Posted By RIDE-F-X
Hate to see you go back and forth, but I wouldn't...

Hate to see you go back and forth, but I wouldn't rule out steering based of his work. Doing his research with the car in the air (assuming 2 post lift with the suspension at full droop) had no...
Forum: Suspension / Brakes / Chassis 12-30-2011, 01:25 PM
Replies: 212
Views: 25,256
Posted By RIDE-F-X
What happens when you try and tighten down the...

What happens when you try and tighten down the nut on the stop of the strut while it is installed? Does it just start to spin the shaft once it's tight or does it get really tight and not spin the...
Forum: Suspension / Brakes / Chassis 12-30-2011, 01:17 PM
Replies: 10
Views: 2,024
Posted By RIDE-F-X
Did you just get lowering coils? The rear coils...

Did you just get lowering coils? The rear coils are usually the shorter. Once you dive into it you'll notice comparisons between the factory and aftermarket matching coils...
Forum: Suspension / Brakes / Chassis 12-27-2011, 12:43 PM
Replies: 212
Views: 25,256
Posted By RIDE-F-X
Hmmm... you were able to check both sides right?...

Hmmm... you were able to check both sides right? Did it still make the noise while you were watching the top part of the struts? The little bit of translational movement and the gap is normal. The...
Forum: Suspension / Brakes / Chassis 12-21-2011, 12:27 PM
Replies: 33
Views: 14,608
Posted By RIDE-F-X
That stuff looks great guys, nice work. That...

That stuff looks great guys, nice work. That knuckle is a sexy work of art my friend, nice job on the innovation. :thumbup:
Forum: Suspension / Brakes / Chassis 12-20-2011, 12:31 PM
Replies: 212
Views: 25,256
Posted By RIDE-F-X
Here's another thing to do, open the hood with...

Here's another thing to do, open the hood with the camaro running. Reach in the and turn the wheel back and forth to see if the upper washer is spinning while you turn. Is there a moderate gap...
Forum: Suspension / Brakes / Chassis 12-19-2011, 12:50 PM
Replies: 212
Views: 25,256
Posted By RIDE-F-X
If you're still looking for suggestions, I would...

If you're still looking for suggestions, I would probably buy one of those upper bearing assemblies ($32 is retail from GM) and see if one side quiets down. If he's feeling it from the spring, that...
Forum: Suspension / Brakes / Chassis 12-16-2011, 12:57 PM
Replies: 212
Views: 25,256
Posted By RIDE-F-X
Was it put back together and driven once you...

Was it put back together and driven once you corrected the coil not sitting in the foam piece on each side? I would find a back alley somewhere with scattered potholes and see if it's just one side...
Forum: Suspension / Brakes / Chassis 12-15-2011, 12:34 PM
Replies: 212
Views: 25,256
Posted By RIDE-F-X
Could be the factory upper coil spring "bearing"....

Could be the factory upper coil spring "bearing". The plastic components ontop of the spring are pretty easy to mangle. That bearing is about one of the only things that was touched during...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-22-2011, 12:46 PM
Replies: 39
Views: 6,029
Posted By RIDE-F-X
I notice that's not hanging over the camaro...

I notice that's not hanging over the camaro :yikes:
Forum: 5th Gen Camaro SS LS LT General Discussions 11-22-2011, 12:21 PM
Replies: 14
Views: 3,155
Posted By RIDE-F-X
:bow: You know your way around this :D

:bow: You know your way around this :D
Forum: Suspension / Brakes / Chassis 11-21-2011, 12:37 PM
Replies: 18
Views: 3,261
Posted By RIDE-F-X
I like that idea the best :) Alot of the...

I like that idea the best :)

Alot of the compression adjustments out there just affect the bleed rate of the fluid to make it "feel firmer" instead of actually adjusting the valving.
Forum: 5th Gen Camaro SS LS LT General Discussions 11-19-2011, 12:34 PM
Replies: 79
Views: 13,815
Posted By RIDE-F-X
For years I traded between Jeeps for 2 years,...

For years I traded between Jeeps for 2 years, Camaro for 2 years, back and forth. I found it's better to own both ;)

Funny thread, didn't know how many other jeepers liked camaro's out there.
Forum: Suspension / Brakes / Chassis 11-18-2011, 01:39 PM
Replies: 18
Views: 3,261
Posted By RIDE-F-X
Wow this poll just got a little closer. :popcorn:...

Wow this poll just got a little closer. :popcorn:

We thought about using a simple/common tool for in trunk adjustment, whether it be screw driver, socket, allen head so the hole isn't so intrusive...
Forum: Camaro Photos | Spyshots | Video | Media Gallery 11-17-2011, 01:01 PM
Replies: 41
Views: 6,403
Posted By RIDE-F-X
Keep an eye out for an upcoming OFFROAD magazine...

Keep an eye out for an upcoming OFFROAD magazine review of that Dodge. It came back with much more damage than the camaro, but at least we did it in the dunes of Vegas and not a truck driver ;)
...
Showing results 1 to 30 of 41
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -5. The time now is 01:29 PM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2025, vBulletin Solutions, Inc.