![]() |
|
|
#29 |
|
Account Suspended
Drives: 2010 Camaro 1SS LS3 Join Date: Jan 2015
Location: Riverside, CA
Posts: 4,018
|
Stock system didn't, but the stock system was soon replaced with slotted/drilled rotors then the squeeling began, even after I installed Ceramic pads.
So, I finally had enough and went on a mission to get rid of the squealing. I took my rotors to get turned and I was going to try on different brake pads until I was satisfied it was gone. It didn't take long... first set and no more squealing. Been a few years now. Turn your rotors, get new pads... if needed, apply that anti-squeal stuff on the backside of your pads to minimize vibration. Good luck! |
|
|
|
|
|
#30 |
![]() ![]() Drives: 2010 Camaro SS Victory Red Join Date: Apr 2015
Location: Rosenberg, Texas
Posts: 780
|
Mine do under light breaking instances, not no much during a panic stop
|
|
|
|
|
|
#31 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2014 Red Hot LS3 Join Date: Oct 2014
Location: SF Bay Area, CA
Posts: 4,266
|
None for me.
|
|
|
|
|
|
#32 |
![]() Drives: 2012 2SS Join Date: Jan 2015
Location: NYC area
Posts: 304
|
Could try lubricating the ways that the pads slide in, make sure if they have a backing plate that its not loose or resonating. 9 times out of 10 I clean up the tabs on the pads, scrape the paint off them, smooth them out, etc, that clears up the real loud squeals I think that is the tabs digging into the caliper when they vibrate.
|
|
|
|
|
|
#33 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: SUMMIT WHITE 2SS/RS CAMARO Join Date: Feb 2008
Location: 2018: Lakewood Ranch, Fl.
Posts: 8,167
|
37,000 miles- Never a peep.
__________________
|
|
|
|
|
|
#34 |
|
MC-12W
Drives: 2006 Civic LX, 2011 Camaro 1SS Join Date: May 2013
Location: S.A TX
Posts: 128
|
mine use to every so often..then i swapped to Slotted rotors and hawk ceramics..and they it went away...along with 95% brake dust
__________________
|
|
|
|
|
|
#35 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2011 SIM 2SS/RS LS3 Join Date: Sep 2013
Location: Tupelo, MS
Posts: 5,902
|
if you hammer on the brakes a few times it'll go away
__________________
2011 2SS/RS built 8/24/10
|
|
|
|
|
|
#36 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
they used to. now they don't...not sure what changed.
|
|
|
|
|
|
#37 |
![]() Drives: none Join Date: Sep 2014
Location: Northern VA
Posts: 66
|
mine do, rotors rust over night figure that is the reason. Kind of annoying.
__________________
1954 Corvette
|
|
|
|
|
|
#38 |
![]() |
Mine squeal under very light braking. They don't squeal under moderate or hard braking.
|
|
|
|
|
|
#39 |
![]() ![]() ![]() ![]() ![]() Drives: 2013 Camaro Dusk 2SS/6 Join Date: Sep 2013
Location: New Jersey
Posts: 1,586
|
so far mine have been super quiet. but yes metallic pads can be noisy. nothing you can' fix with some nice Akebono ceramic pads. They don't have track stopping power but quiet and dust free.
|
|
|
|
|
|
#40 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2014 2SS/RS Camaro Join Date: Dec 2014
Location: Kentucky
Posts: 2,420
|
Mine are silent... I think. My car is a bit loud, and I usually have the stereo cranked up pretty good.
You could always get a louder exhaust.
__________________
2014 2SS/RS, L99, SW LTH w/HF Cats, GMPP Ex. Z/28 CAI, FR41s in PVD Black Chrome, Recaros, Pfadt Sway
377hp, 383tq 12.739@110.44 MPH |
|
|
|
|
|
#41 |
|
Love me some Tacos
|
Not that this happened to you, but I know that if say cleaning wheels some detail spray gets on rotors... can cause pads to squeak.
|
|
|
|
|
|
#42 |
![]() Drives: 2011 Camaro Convertible SS Join Date: Jul 2012
Location: Blanchester, OH
Posts: 32
|
I had the same problem as well. Went to the dealer and finally discovered that GM had put out a service bulletin to the dealers not to replace pads, etc. due to the squealing. I solved my issue like Riscouave did by switching to slotted rotors and ceramic pads.
|
|
|
|
|
|
|
|
![]() |
|
|