Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
KPM Fuel Systems
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.03 seconds.
Search: Posts Made By: Risingson05
Forum: 5th Gen Camaro SS LS LT General Discussions 11-30-2025, 03:47 PM
Replies: 21
Views: 751
Posted By Risingson05
lol just looked up cost for me of big gulp . The...

lol just looked up cost for me of big gulp . The big gulp and relocation bottle puts me into over 700.00 plus a cost of a retune . I’m thinking of the gains from this and I think it’ll be minimal...
Forum: 5th Gen Camaro SS LS LT General Discussions 11-30-2025, 02:58 PM
Replies: 21
Views: 751
Posted By Risingson05
True

True
Forum: 5th Gen Camaro SS LS LT General Discussions 11-30-2025, 11:21 AM
Replies: 21
Views: 751
Posted By Risingson05
I’m running a reg roto-fab intake . Was told by...

I’m running a reg roto-fab intake . Was told by my tuner ,it was not worth it unless I get up to bigger cubes ,only so much air can go into our cylinders .

Although,I do see a lot of people...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 08-21-2025, 10:52 AM
Replies: 7
Views: 2,304
Posted By Risingson05
+1

+1
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 07-12-2025, 10:12 AM
Replies: 9
Views: 928
Posted By Risingson05
Always check the water grains in the humidity...

Always check the water grains in the humidity index before racing . Will give you an idea of the performance your going to be dishing out
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 05-04-2025, 02:43 PM
Replies: 29
Views: 2,350
Posted By Risingson05
I had my motor out and when looking at the cam...

I had my motor out and when looking at the cam bearing I didn’t liked what I saw , so decided to replace them .

Most don’t replace cam bearings when doing a cam . Although, I’m sure it’s possible...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 05-04-2025, 12:52 PM
Replies: 29
Views: 2,350
Posted By Risingson05
Pressure relief valve could be sticking but I...

Pressure relief valve could be sticking but I doubt it .


Might be too late but would have been a good ideas to have your filter cutt open to inspect if there’s and bearing material in the...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 04-12-2025, 11:41 AM
Replies: 5
Views: 3,113
Posted By Risingson05
I just run distilled water and water wetter

I just run distilled water and water wetter
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 02-17-2025, 07:16 PM
Replies: 15
Views: 7,581
Posted By Risingson05
Congrats on the purchase

Congrats on the purchase
Forum: 5th Gen Camaro SS LS LT General Discussions 01-05-2025, 08:25 PM
Replies: 1,939
Views: 239,505
Posted By Risingson05
Nice !! Now you can go deeper into the corners...

Nice !! Now you can go deeper into the corners and brake to the point your eyes feel like their popping out lol
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 01-05-2025, 08:12 PM
Replies: 7
Views: 8,525
Posted By Risingson05
Sounds like your clutch is slipping . How old is...

Sounds like your clutch is slipping . How old is the clutch ? Could be number of issue from worn out from hard launches to bad clutch/brake fluid if it doesn’t have a dedicated resivior. Or if new...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 12-09-2024, 10:49 AM
Replies: 24
Views: 10,238
Posted By Risingson05
Umm- what? I’m running Mickeys ET street R’s 17’s...

Umm- what? I’m running Mickeys ET street R’s 17’s hooks up way better than nitto ever could , especially on the launch
Forum: 5th Gen Camaro SS LS LT General Discussions 10-07-2024, 09:34 PM
Replies: 425
Views: 66,004
Posted By Risingson05
Named my z Sorry bout the sideways pic :bonk:

Named my z
Sorry bout the sideways pic :bonk:
Forum: 5th Gen Camaro SS LS LT General Discussions 09-29-2024, 10:51 AM
Replies: 7
Views: 936
Posted By Risingson05


Forum: 5th Gen Camaro SS LS LT General Discussions 09-29-2024, 10:21 AM
Replies: 7
Views: 936
Posted By Risingson05
Vland c8 taillights

https://www.vlandus.com/products/vland-led-taillights-for-2014-2015-chevrolet-camaro?variant=45090375401730

Who has these ? How’s fit &finish and quality ? Was wanting the umbra series but they...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-29-2024, 09:17 AM
Replies: 15
Views: 1,489
Posted By Risingson05
Hate that damn hill assist .

Hate that damn hill assist .
Forum: 5th Gen Camaro SS LS LT General Discussions 06-23-2024, 01:05 PM
Replies: 4,108
Views: 689,154
Posted By Risingson05
I know right ! , when the entry for the calendar...

I know right ! , when the entry for the calendar started was during the winter and I didn’t have any pic’s of the coast ,as road construction has been going on down there for couple years and finally...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-22-2024, 11:43 PM
Replies: 4,108
Views: 689,154
Posted By Risingson05
Took little drive down the coat figured take a...

Took little drive down the coat figured take a pic -enjoy :thumbup:
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 06-17-2024, 11:47 AM
Replies: 5
Views: 1,339
Posted By Risingson05
Sorry - 1/4 mile . That pass was with a 1.70 60ft...

Sorry - 1/4 mile . That pass was with a 1.70 60ft - I’ll post slips later today .
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 06-17-2024, 09:47 AM
Replies: 5
Views: 1,339
Posted By Risingson05
Da was 813 that day elevations is is 75ft. Thanks...

Da was 813 that day elevations is is 75ft. Thanks guys
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 06-16-2024, 03:55 PM
Replies: 19
Views: 6,840
Posted By Risingson05
Could be the bearing support cup melted , you...

Could be the bearing support cup melted , you should jack up the car and look inside the bell housing thru the inspection hole to see if anything is leaking there . Also: are you sure you bled all...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-16-2024, 10:37 AM
Replies: 12
Views: 1,214
Posted By Risingson05
:thumbup:

:thumbup:
Forum: 5th Gen Camaro SS LS LT General Discussions 06-16-2024, 10:35 AM
Replies: 16
Views: 2,742
Posted By Risingson05
Line lock will help you out

Line lock will help you out
Forum: 5th Gen Camaro SS LS LT General Discussions 06-16-2024, 10:34 AM
Replies: 6
Views: 23,600
Posted By Risingson05
Melted bearing support cup

Melted bearing support cup
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 06-16-2024, 04:14 AM
Replies: 5
Views: 1,339
Posted By Risingson05
New pb - 10.5

https://youtu.be/x--gvXRGSVs?feature=shared

Here’s another one - running down a c8 after a bad launch .

https://youtu.be/AEKc4Svx_cI?feature=shared


I would have beat my time on the last...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-11-2024, 10:40 AM
Replies: 13
Views: 6,433
Posted By Risingson05
I used a green scotchbrite and plastic razor...

I used a green scotchbrite and plastic razor blade with WD-40 to clean the carbon off and used denatured alcohol to wipe it down before installing the head gasket .
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 01-05-2024, 04:18 PM
Replies: 24
Views: 13,731
Posted By Risingson05
Hmm I’m pushing more boost than you . I’ve hot...

Hmm I’m pushing more boost than you . I’ve hot lapped my car 4times before my iat’2 exceeded 140. That without ice in the tank - I’m running 6gal trunk tank with emp pump
Forum: 5th Gen Camaro SS LS LT General Discussions 01-03-2024, 10:34 PM
Replies: 32
Views: 1,823
Posted By Risingson05
I don’t measure my gas in mileage - I measure it...

I don’t measure my gas in mileage - I measure it with smiles !!:thumbup: Lol
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-21-2023, 10:05 PM
Replies: 13
Views: 6,156
Posted By Risingson05
Who are you going to have tune it ? I’m running a...

Who are you going to have tune it ? I’m running a pat g max effort cam and he’s my tuner and I love it !! His service are top notch as well ..

Can’t go wrong with pat - he’s been around a long...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-06-2023, 07:41 PM
Replies: 101
Views: 13,731
Posted By Risingson05
Where does the hoses connect to ? You mentioned...

Where does the hoses connect to ? You mentioned they went towards the firewall? Might wanna show a pic ,so we have a better understanding where those hoses go to . Otherwise I mean you could always...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 04:58 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.